ابوالفضل دهقان منفرد

Wettability alteration of rock surfaces toward gas wetting have been recognized as a practical approach for maximizing the production from the gas condensate reservoirs. Most of the reported work in this area applied the so called sessile drop contact angle measurement technique to examine the change in wetting state of a surface. However, the size-dependent wetting behavior of drop which could affect the exact determination of wettability and wettability changes was not well discussed in the previous studies. Therefore, in this work, the size dependency of contact angle for four different liquid-solid-gas systems; i.e., water-calcite-air, water-treated calciteair (nanofluid treated calcite), oil-calcite-air, and oil-treated calcite-air, were investigated. To provide a better understanding of the displacement of reservoir gas and liquid following the wettability alteration process, a dynamic contact angle measurement approach was designed. The effect of drop size and surface roughness on the wetting state of calcite rock samples at the initial and altered condition of wettability was then investigated through experimental and modeling approaches. The surface roughness of calcite samples and drop contact angles were determined using Atomic Force Microscopy and Low bond axisymmetric drop shape analysis method, respectively. Analysis of results demonstrated that size dependency of contact angle imposed an error as high as 22.2° on the measurement of achieved wettability alteration in the case of water-calcite/treated calciteair system. On the basis of calculated pseudo-line tension from the modeling schemes, it was also revealed that the surface roughness had a significant impact on wettability measurements. Both low and high pseudo-line tension values of order 10?9 and 10?6 N, respectively, could dictate some level of errors in contact angle measurements. However, high values were supposed to have a considerable degree of importance in gas condensate applications. The