November 25, 2024
Mohammad Vaghefi

Mohammad Vaghefi

Academic Rank: Associate professor
Address:
Degree: Ph.D in Hydraulic Structures
Phone: 077-31342401
Faculty: Faculty of Engineering

Research

Title Experimental comparison of flow pattern around convergent-vertical and divergent-vertical pier groups located in a 180 degree sharp bend with streamwise direction
Type Article
Keywords
flow pattern; 180degree sharp bend; 3d velocity; convergent-vertical; divergent-vertical.
Journal ISH Journal of Hydraulic Engineering
DOI https://doi.org/10.1080/09715010.2023.2194853
Researchers Mohammad Vaghefi (First researcher) ,

Abstract

The flow pattern at the meandering rivers changes to a helical flow. The installation of bridge piers on the meandering river and collision of the flow with pier geometry creates a far more complicated flow. The experiments were performed in a 180-degree bend channel and a radius to curvature ratio of two. The flow pattern around the bridge pier group and along the bend was investigated. The pier groups were installed in convergent-vertical in streamwise direction (CVS) and divergent-vertical in streamwise direction (DVS). The results show that the earliest eddy flows in the convergent-vertical pier groups were formed at near water surface level. According to the findings, the formation of return flow from a 77.5degree angle and at a distance of 35 to 45 percent of the width of the channel from the inner bank happened. However, the return flows were initiated from the 87.5degree and at a distance of 60 to 70% of the width of the channel from the inner bank in the divergent-vertical pier group. The power of secondary flow in convergent-vertical and divergent-vertical pier groups occurred at 85 and 87.5degree sections respectively, and equal to 3.5 and 1.25 times the pier diameter from the center of the piers’ location upstream