October 12, 2024
Yasser Amini

Yasser Amini

Academic Rank: Associate professor
Address:
Degree: Ph.D in Mechanical Engineering
Phone: 07731222171
Faculty: Faculty of Engineering

Research

Title Effects of splitter plate and mass ratio on flow-induced vibration and heat transfer characteristics of a circular cylinder in turbulent flow: A numerical study
Type Article
Keywords
Forced convection heat transfer Flow-induced vibration Splitter plate Turbulent flow
Journal INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER
DOI https://doi.org/10.1016/j.ijheatmasstransfer.2023.
Researchers Ali Ashouri (First researcher) , Ehsan Izadpanah (Second researcher) , Yasser Amini (Third researcher) , Seyed Hamed Meraji (Fourth researcher)

Abstract

The two-degree-of-freedom (2DOF) flow-induced vibration (FIV) of a circular cylinder with heat transfer in turbulent flow is numerically investigated. The cylinder with an attached splitter plate is elastically supported and allowed to vibrate in both in-line and transverse directions. The unsteady RANS and energy equations along with the SST k-ω turbulent model are coupled with the equation of vibration to study the FIV of the cylinder. The effects of the attached plate length (L/D = 0.5, 1.0, and 1.5) and the mass ratio (mr = 2 and 6.76) on the heat transfer rate, vortex shedding patterns, vibration trajectories, FFT, and cylinder displacements are studied in a wide range of Reynolds number (1156–9246) and reduced velocity (2–16). The results indicate that FIV can have either a positive or negative effect on heat transfer enhancement, depending on the splitter plate length and the type of cylinder vibration response. At high Reynolds numbers, the cylinder vibration response is observed in the galloping region, accompanied by a significant vibration amplitude. In this region, for L = 0.5D, vibration has a positive effect on heat transfer, while for other lengths, this effect is negative. For L = 1.5D and a reduced velocity of 5.5, contributions of vortex-induced vibration (VIV) and surface area in the heat transfer enhancement are 23.5 % and 44.3 %, respectively. By reducing the mass ratio from 6.76 to 2.6 for L = 0.5D, the heat transfer rate increases by approximately 40 % compared to a stationary cylinder.